Push Yellow Start/Stop Button - it will beep and all settings will turn green. Push Yellow button again and it will go from setting 1 to .5 then it will stop on 1 and 1.0 If this is your first setting push the Yellow button a third time and it will start the treatment - the green setting light will blink and a red light (laser)will be emitted Do Not Shine It Toward Your Eyes. Hold so it is in contact with treatment area. When the treatment setting is complete it will beep and the green setting light will stop blinking. If you are going to repeat the treatment at this setting push the Yellow button again, if you are going to a different setting push the Red button until it cycles to the correct setting then push the Yellow button to start. If you chose a treatment setting that starts incorrectly you can stop it by pushing the Yellow Start/Stop button then use the Red button to get to the correct setting. Once you are done push the Yellow button and hold in that position for a few seconds and it will turn off.

(PAGES ~ 583.48Kb)

(PDF ~ 1.12Mb)

(PDF ~ 2.9Mb)

(PDF ~ 2.9Mb)